[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
There are some very annoying problems with the DVNR1000 that I would like to
bring up to see if anyone has had the same problems, and if there are solutions
that DV does not know about.
1) Digital mattes (top and bottom blanking adjust) leave 2 lines of video at
the top of the picture poking through. Switch on SCO board fills in this
hole with the mattes in, but adds black to line 22 with the mattes out.
2) Above mentioned mattes not programmable.
3) Primaries and secondaries are not 3:2 aware for NTSC film to tape work.
4) No setup on YUV outputs for NTSC Betacam.
Blue Water Post