[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]


Hello David,

Grant is right, it would be better to install independent 
connectors; some customers only need a Keycode head, others 
simultaneously run Keycode, AatonCode and ArriFis readers.
The AatonCode CCD reader is SubD-9 wired already; to rewire 
its connector --which carries shielded HF signals-- would 
not be an easy task.  
For us, 2x D-9 would be fine but 3, peace at last as I am 
not sure the Alperman/ArriFis reader would be happy to 
share our HF signals in a common D-25!

The TK operator should see one D-9 female and one D-9 male 
to eliminate misplugging. As for the third... why not consult
Alperman, CP and Evertz to avoid immediate babelisation 
of this long sought after passageway?

Best regards,

--Jean-Pierre Beauviala

> From:        grant.petty at nexus.net.au
> To:          Tig, telecine at sun.alegria.com

>> In response to comments made on the TIG forum, Cintel has 
>> investigated how to fit a 25 way ancillary socket to the 
>> Ursa Gold / Diamond Deck plate area. We have established that 
>> this can be done in a way that does not compromise the EMC  
>> rating of the machine (Drilling holes in the deck plate is 
>> far morecomplex than just providing a hole)... deletia...

> That's great that you will add a connector to the deck plate, 
> but could you add two D-9's instead of one large one, as that 
> way you could use one for each of the AATON reader head, without 
> trying to combine them.   ...deletia...
> The two deck plate connectors should then connect pin for pin 
> to their respective connectors on the back panel of the URSA. 
> That way any two different devices can be added independently.
> Regards, Grant Petty, Complete Post, Melbourne, Australia.